[ClusterLabs] Which verson of pacemaker/corosync provides crm_feature_set 3.0.10?

[vitaly]

Thank you!
I understand the purpose. We did not hit the problem with this issue until there was some failure during upgrade at the customer site and the old node died. New one came up and old node was never able to join until we killed new one and started old in the single node mode.
My question about rpms was related to pacemaker vs corosync rpms. I guess that crm_feature_set is defined in pacemaker rpms. 
I understand that all rpms built for pacemaker have to be same version as should all rpms built for corosync.
If 1.1.15 uses 3.0.10 I will try 1.1.15 then.
Thank you very much for your help!
_Vitaly

> On November 23, 2021 5:12 PM Ken Gaillot <kgaillot at redhat.com> wrote:
> 
>  
> On Tue, 2021-11-23 at 14:11 -0500, vitaly wrote:
> > Hello,
> > I am working on the upgrade from older version of pacemaker/corosync
> > to the current one. In the interim we need to sync newly installed
> > node with the node running old software. Our old node uses pacemaker
> > 1.1.13-3.fc22 and corosync 2.3.5-1.fc22 and has crm_feature_set
> > 3.0.10.
> > 
> > For interim sync I used pacemaker 1.1.18-2.fc28 and corosync 2.4.4-
> > 1.fc28. This version is using crm_feature_set 3.0.14. 
> > This version is working fine, but it has issues in some edge cases,
> > like when the new node starts alone and then the old one tries to
> > join.
> 
> That's the intended behavior of mixed-version clusters -- once an older
> node leaves the cluster, it can't rejoin without being upgraded. This
> allows new features to become available once all older nodes are gone.
> 
> Mixed-version clusters should only be used in a rolling upgrade, i.e.
> upgrading each node in turn and returning it to the cluster.
> 
> > 
> > So I need to rebuild rpms for crm_feature_set 3.0.10. This will be
> > used just once and then it will be upgraded to the latest versions of
> > pacemaker and corosync.
> > 
> > Now, couple of questions:
> > 1. Which rpm defines crm_feature_set?
> 
> The feature set applies to all RPMs of a particular version. You can't
> mix and match RPMs from different versions.
> 
> > 2. Which version of this rpm has crm_feature_set 3.0.10?
> 
> The feature set of each released version can be seen at:
> 
> https://wiki.clusterlabs.org/wiki/ReleaseCalendar
> 
> 1.1.13 through 1.1.15 had feature set 3.0.10
> 
> > 3. Where could I get source rpms to rebuild this rpm on CentOs 8?
> > Thanks a lot!
> > _Vitaly Zolotusky
> 
> The stock packages in the repos should be fine. All newer versions
> support rolling upgrades from 1.1.13.
> 
> > 
> -- 
> Ken Gaillot <kgaillot at redhat.com>