<br><br>On Friday, February 11, 2022, john tillman <<a href="mailto:johnt@panix.com">johnt@panix.com</a>> wrote:<br>> Hypothetically, if I have a two node cluster on identical VMs without<br>> fencing and I see transitions take longer in one direction than the other.<br>>  What are some possible reasons?<br>><br>> For example, "pcs node standby nodeX" or "pcs cluster stop nodeX" results<br>> in a very fast transition to nodeY.  However, given the same commands but<br>> going from nodeY to nodeX takes much, much longer.<br>><br>> And note that powering off either VM does *not* exhibit this behavior and<br>> transitions times in both direction are the same, fast.<br>><br>> Best regards,<br>> -John<br>><br><br>I'm assuming that in all cases, your resources are all running on the node that you're stopping or putting into standby mode. Otherwise, it could be a matter of "having to do work" versus "not having to do work."<br><br>With that said, it could be that the node that's acting as DC is slower to stop or start resources than the non-DC node, because the scheduler and controller daemons have to do more work there. Or it could simply be that there are non-cluster-related workload differences between the two VMs.<br><br>- Reid<br>><br>> _______________________________________________<br>> Manage your subscription:<br>> <a href="https://lists.clusterlabs.org/mailman/listinfo/users">https://lists.clusterlabs.org/mailman/listinfo/users</a><br>><br>> ClusterLabs home: <a href="https://www.clusterlabs.org/">https://www.clusterlabs.org/</a><br>><br>><br><br>-- <br><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><div dir="ltr"><div><div>Regards,<br><br></div>Reid Wahl (He/Him), RHCA<br></div><div>Senior Software Maintenance Engineer, Red Hat<br></div>CEE - Platform Support Delivery - ClusterHA</div></div></div></div></div></div></div></div></div></div></div></div></div><br>