# Please read the corosync.conf.5 manual page
totem {
    version: 2
    # Token timeout 10 secs...5 attempts
    token: 10000
    token_retransmits_before_loss_const: 5
    # crypto_cipher and crypto_hash: Used for mutual node authentication.
    # If you choose to enable this, then do remember to create a shared
    # secret with "corosync-keygen".
    # enabling crypto_cipher, requires also enabling of crypto_hash.
    #crypto_cipher: none
    #crypto_hash: none
    crypto_cipher: aes256
    crypto_hash: sha256
    # interface: define at least one interface to communicate
    # over. If you define more than one interface stanza, you must
    # also set rrp_mode.
	
	rrp_mode: passive
	
    interface {
        # Rings must be consecutively numbered, starting at 0.
        ringnumber: 0
        # This is normally the *network* address of the
        # interface to bind to. This ensures that you can use
        # identical instances of this configuration file
        # across all your cluster nodes, without having to
        # modify this option.
        bindnetaddr: 10.10.230.0 #MGMT
        # However, if you have multiple physical network
        # interfaces configured for the same subnet, then the
        # network address alone is not sufficient to identify
        # the interface Corosync should bind to. In that case,
        # configure the *host* address of the interface
        # instead:
        # bindnetaddr: 192.168.1.1
        # When selecting a multicast address, consider RFC
        # 2365 (which, among other things, specifies that
        # 239.255.x.x addresses are left to the discretion of
        # the network administrator). Do not reuse multicast
        # addresses across multiple Corosync clusters sharing
        # the same network.
        mcastaddr: 239.255.1.1
        # Corosync uses the port you specify here for UDP
        # messaging, and also the immediately preceding
        # port. Thus if you set this to 5405, Corosync sends
        # messages over UDP ports 5405 and 5404.
        mcastport: 5405
        # Time-to-live for cluster communication packets. The
        # number of hops (routers) that this ring will allow
        # itself to pass. Note that multicast routing must be
        # specifically enabled on most network routers.
        ttl: 1
    }
	
}
logging {
    # Log the source file and line where messages are being
    # generated. When in doubt, leave off. Potentially useful for
    # debugging.
    fileline: off
    # Log to standard error. When in doubt, set to no. Useful when
    # running in the foreground (when invoking "corosync -f")
    to_stderr: yes
    # Log to a log file. When set to "no", the "logfile" option
    # must not be set.
    #to_logfile: yes
    #logfile: /var/log/corosync.log
    # Log to the system log daemon. When in doubt, set to yes.
    to_syslog: yes
    # Log debug messages (very verbose). When in doubt, leave off.
    debug: off
    # Log messages with time stamps. When in doubt, set to on
    # (unless you are only logging to syslog, where double
    # timestamps can be annoying).
    timestamp: on
    logger_subsys {
        subsys: QUORUM
        debug: off
    }
}
quorum {
    # Enable and configure quorum subsystem (default: off)
    # see also corosync.conf.5 and votequorum.5
    provider: corosync_votequorum
    expected_votes: 1
}