[ClusterLabs] PCS, Corosync, Pacemaker, and Bind (Ken Gaillot)

[Mike Bernhardt]

I guess I have to say "never mind!" I don't know what the problem was
yesterday, but it loads just fine today, even when the named config and the
virtual ip don't match! But for your edamacation, ifconfig does NOT show the
address although ip addr does:

ip addr
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN 
    link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
    inet 127.0.0.1/8 scope host lo
       valid_lft forever preferred_lft forever
    inet6 ::1/128 scope host 
       valid_lft forever preferred_lft forever
2: eth0: <BROADCAST,MULTICAST,UP,LOWER_UP> mtu 1500 qdisc mq state UP qlen
1000
    link/ether 00:50:56:8b:d0:f7 brd ff:ff:ff:ff:ff:ff
    inet 192.168.30.36/26 brd 192.168.30.63 scope global eth0
       valid_lft forever preferred_lft forever
    inet 192.168.30.38/26 brd 192.168.30.63 scope global secondary eth0
       valid_lft forever preferred_lft forever

ifconfig -a eth0
eth0: flags=4163<UP,BROADCAST,RUNNING,MULTICAST>  mtu 1500
        inet 192.168.30.36  netmask 255.255.255.192  broadcast 192.168.30.63
        ether 00:50:56:8b:d0:f7  txqueuelen 1000  (Ethernet)
        RX packets 1169357  bytes 163514247 (155.9 MiB)
        RX errors 0  dropped 4639  overruns 0  frame 0
        TX packets 1351613  bytes 210957790 (201.1 MiB)
        TX errors 0  dropped 0 overruns 0  carrier 0  collisions 0