[Pacemaker] Monitoring on master node not running after standby is connected

Juraj Fabo juraj.fabo at gmail.com
Tue Oct 15 13:21:06 UTC 2013


Juraj Fabo <juraj.fabo at ...> writes:
> 
> Hello Andrew
> 
> 
> thank you for the response.
> 
> I've patched crmd, cleaned the cluster, done the scenario steps and 
created crm_report which is attached.
> 
> After loading the cluster configuration both nodes were running the IFDS-
Stateful resource monitoring properly, however after restarting pacemaker on 
the slave node monitoring on the master node was cancelled
> 
> 
> ifds1 was slave, monitoring of IFDS-Stateful running 11seconds interval
> ifds2 was master,  monitoring of IFDS-Stateful running 10 seconds 
intervallog messages in ifds_ha.log
> 
> 
> with best regards 
> 
> 
> 
> Juraj
> 

Hello

I've downgraded pacemaker in my cluster to version 1.1.8 just to see whether 
the monitoring of master slave resource will be running on both nodes in 
parallel.
It is actually running, after entering HotStandby node the monitoring on 
hotstandby is monitoring postgresql resource in defined interval and on 
master in interval defined for role master.
This time I used my target config with postgresql and other resource, I do 
not have logs for test cluster with dummy "Stateful" resource.

Now I'm confused due to fact, that using 1.1.8 pacemaker (in which this bug 
was fixed) is ok, while 1.1.10 not - at least in my config and according to 
my understanding. I did not see other reports with similar symptoms, but 
OTOH with 1.1.8 monitoring is running on both nodes.

Should I provide some more logs/symptoms from 1.1.10 case to be able to 
proceed?

Thank you in advance

Juraj






More information about the Pacemaker mailing list