[Pacemaker] How to perform a clean shutdown of Pacemaker in the event of network connection loss

Tan Tai hock taihock at gmail.com
Fri Jul 26 00:44:53 UTC 2013


Ops sorry for providing the wrong version number. I am using Corosync
2.3.0-1 and Pacemaker 1.1.9-8. What should be done to clear the resources
properly that are still running in the event that pacemaker isn't running?


On Thu, Jul 25, 2013 at 10:39 AM, Andrew Beekhof <andrew at beekhof.net> wrote:

>
> On 24/07/2013, at 6:40 PM, Tan Tai hock <taihock at gmail.com> wrote:
>
> >
> > I did not enable fencing. I observe the process running and see that
> when the node is up, I will see the following processes:
> >
> > Corosync
> > --------------
> > /usr/sbin/corosync
> >
> > Pacemaker
> > -----------------
> > /usr/libexec/pacemaker/lrmd
> > /usr/libexec/pacemaker/pengine
> > pacemakerd
> > /usr/libexec/pacemaker/stonith
> > /usr/libexec/pacemaker/cib
> > /usr/libexec/pacemaker/crmd
> >
> > If I were to shutdown the network connection of any node and then list
> out the processes, I will see that "/usr/sbin/corosync" is no longer
> running  and for Pacemaker, the following processes are left:
> >
> > Pacemaker
> > -----------------
> > /usr/libexec/pacemaker/lrmd
> > /usr/libexec/pacemaker/pengine
>
> corosync has probably crashed and taken most of pacemaker with it (all
> this bits that connect to corosync).
> what versions are you running? because neither "Pacemaker 2.3" nor
> "Corosync 1.19" exist.
>
> In any case, the resources are still running there - even if pacemaker
> isn't.
>
> If you want to simulate an outage, use firewall rules to block traffic
> to/from the node.
> If you want to simulate someone opening the box and pulling out it's NIC -
> keep using ifconfig down.
>
> >
> > If there is no network connectivity loss and I perform a clean shutdown,
> I do not see any of the processes listed for Corosync and Pacemaker. I
> tried to kill the remaining process after network connection is lost but
> that does not prevent the fallen node from getting back the resource if it
> used to be holding it before going down.
> >
> > Is there a way to perform a clean shutdown if pacemaker was shutdown
> improperly?
> >
> >
> > On Wed, Jul 24, 2013 at 8:21 AM, Andrew Beekhof <andrew at beekhof.net>
> wrote:
> >
> > On 24/07/2013, at 9:54 AM, Tan Tai hock <taihock at gmail.com> wrote:
> >
> > > No I did not. It seems like corosync and pacemaker stop running when
> the network connection is lost.
> >
> > Do you have fencing enabled?
> > If not, I'd be surprised if corosync or pacemaker stopped running.
> >
> > > I am trying to simulate a scenario whereby a node which started the
> resource loses network connection and observe how it reacts upon joining
> back the cluster. Is there any proper way to shutdown both corosync and
> pacemaker in such scenario?
> >
> > They are not supposed to stop running just because connectivity was lost.
> >
> > >
> > > On Jul 24, 2013 6:55 AM, "Andrew Beekhof" <andrew at beekhof.net> wrote:
> > >
> > > On 23/07/2013, at 11:28 AM, Tan Tai hock <taihock at gmail.com> wrote:
> > >
> > > > Hi,
> > > >
> > > > I have currently set up 3 machines with Pacemaker 2.3 with Corosync
> 1.19. I have tested some scenarios and have encountered some problem which
> I hope to get some advice on.
> > > >
> > > > My scenario is as follows:
> > > >
> > > > The 3 machines, name A,B,C are all running with A being the node
> which started the resource as seen in cm_mon. If I were to cut off the
> network connection for A, B will take over as the node which started the
> resource. I then resume the network connection and start both corosync and
> pacemaker on A again
> > >
> > > Did you stop it there first?
> > >
> > > > and the node which started the resource now returns to node A.
> > > > I have set stickness and perform an identical test but with proper
> shutdown of pacemaker and corosync and it is working fine.
> > > > Is there anyway to perform a clean shutdown in the event that a node
> loses network connection so that it will not attempt to take back the
> resource it used to be holding before it was uncleanly shutdown?
> > > >
> > > > Thanks
> > > > _______________________________________________
> > > > Pacemaker mailing list: Pacemaker at oss.clusterlabs.org
> > > > http://oss.clusterlabs.org/mailman/listinfo/pacemaker
> > > >
> > > > Project Home: http://www.clusterlabs.org
> > > > Getting started:
> http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
> > > > Bugs: http://bugs.clusterlabs.org
> > >
> > >
> > > _______________________________________________
> > > Pacemaker mailing list: Pacemaker at oss.clusterlabs.org
> > > http://oss.clusterlabs.org/mailman/listinfo/pacemaker
> > >
> > > Project Home: http://www.clusterlabs.org
> > > Getting started:
> http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
> > > Bugs: http://bugs.clusterlabs.org
> > > _______________________________________________
> > > Pacemaker mailing list: Pacemaker at oss.clusterlabs.org
> > > http://oss.clusterlabs.org/mailman/listinfo/pacemaker
> > >
> > > Project Home: http://www.clusterlabs.org
> > > Getting started:
> http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
> > > Bugs: http://bugs.clusterlabs.org
> >
> >
> > _______________________________________________
> > Pacemaker mailing list: Pacemaker at oss.clusterlabs.org
> > http://oss.clusterlabs.org/mailman/listinfo/pacemaker
> >
> > Project Home: http://www.clusterlabs.org
> > Getting started: http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
> > Bugs: http://bugs.clusterlabs.org
> >
> > _______________________________________________
> > Pacemaker mailing list: Pacemaker at oss.clusterlabs.org
> > http://oss.clusterlabs.org/mailman/listinfo/pacemaker
> >
> > Project Home: http://www.clusterlabs.org
> > Getting started: http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
> > Bugs: http://bugs.clusterlabs.org
>
>
> _______________________________________________
> Pacemaker mailing list: Pacemaker at oss.clusterlabs.org
> http://oss.clusterlabs.org/mailman/listinfo/pacemaker
>
> Project Home: http://www.clusterlabs.org
> Getting started: http://www.clusterlabs.org/doc/Cluster_from_Scratch.pdf
> Bugs: http://bugs.clusterlabs.org
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.clusterlabs.org/pipermail/pacemaker/attachments/20130726/d3758c3e/attachment.htm>


More information about the Pacemaker mailing list