[Pacemaker] two nodes fenced when drbd link fails

Vadym Chepkov vchepkov at gmail.com
Fri May 14 02:03:23 UTC 2010


On May 13, 2010, at 1:37 PM, Ivan Coronado wrote:

> Hello to everybody,
>  
> I have a problem with the corosync.conf setup. I have a drbd service runing on eth3, and a general network and the stonith device (idrac6) in the eth0. If I unplug the eth3 to simulate a network failure two nodes are fenced (first the slave followed by the master). If I only leave ringnumber 0 in the coroync.conf file I don't have this problem. Is this normal operation?
>  
> Here you have the section of corosync.conf where I have the problem, and thanks for the help.
>  
>         rrp_mode: active
>         interface {
>                 # eth0
>                 ringnumber: 0
>                 bindnetaddr: 200.200.201.0
>                 mcastaddr: 226.94.1.1
>                 mcastport: 5405
>         }
>         interface {
>                 #eth3
>                 ringnumber: 1
>                 bindnetaddr: 192.168.2.0
>                 mcastaddr: 226.94.1.2
>                 mcastport: 5406
>         }
> -----
> Ivan


I read in the list openais at lists.osdl.org setting ports at least two apart helps (5405, 5407)

Vadym

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.clusterlabs.org/pipermail/pacemaker/attachments/20100513/b28fca0a/attachment-0002.htm>


More information about the Pacemaker mailing list