[Pacemaker] IPMI Stonith

Lars Marowsky-Bree lmb at suse.de
Tue Jan 27 23:44:29 UTC 2009


On 2009-01-20T17:21:39, Adrian Chapela <achapela.rexistros at gmail.com> wrote:

> It is accessed over lan, you need a server with "IPMI over LAN" like 
> Integrated Lights-Out from HP, most known as iLo ( 
> http://h18013.www1.hp.com/products/servers/management/ilo/ ). iLo has a 
> network port that you can use to control a server remotely.
> 
> I think a good way (if the server are near...) could be use a cross-over 
> ethernet wire.

Cross-over of course doesn't work for more than 2 nodes ;-)

Usually, having the IPMI device on one of the cluster LANs suffices.

You need two failures for the cluster to freeze then: the IPMI LAN going
down, _and_ a node failure/additional network failure. 

As the HA cluster tends to only protect against single failures (it is
usually very possible to construct a scenario of two failures which
bring down the entire cluster), that guarantee still holds.

It's all a question of paranoia of course, but k-fault-tolerance for k >
1 is really quite difficult in the general case, even though special
cases (ie, a 5 node cluster can tolerate 2 node failures) is possible.


Regards,
    Lars

-- 
Teamlead Kernel, SuSE Labs, Research and Development
SUSE LINUX Products GmbH, GF: Markus Rex, HRB 16746 (AG Nürnberg)
"Experience is the name everyone gives to their mistakes." -- Oscar Wilde





More information about the Pacemaker mailing list