[Pacemaker] How to setup STONITH in a 2-node active/passive linux HA pacemaker cluster?

[Mathias Nestler]

On 19.03.2012, at 20:26, Florian Haas wrote:

> On Mon, Mar 19, 2012 at 8:14 PM, Mathias Nestler
> <mathias.nestler at barzahlen.de> wrote:
>> Hi everyone,
>> 
>> I am trying to setup an active/passive (2 nodes) Linux-HA cluster with corosync and pacemaker to hold a PostgreSQL-Database up and running. It works via DRBD and a service-ip. If node1 fails, node2 should take over. The same if PG runs on node2 and it fails. Everything works fine except the STONITH thing.
>> 
>> Between the nodes is an dedicated HA-connection (10.10.10.X), so I have the following interface configuration:
>> 
>> eth0                        eth1                   host
>> 10.10.10.251    172.10.10.1     node1
>> 10.10.10.252    172.10.10.2     node2
>> 
>> Stonith is enabled and I am testing with a ssh-agent to kill nodes.
>> 
>> crm configure property stonith-enabled=true
>> crm configure property stonith-action=poweroff
>> crm configure rsc_defaults resource-stickiness=100
>> crm configure property no-quorum-policy=ignore
>> 
>> crm configure primitive stonith_postgres stonith:external/ssh \
>>               params hostlist="node1 node2"
>> crm configure clone fencing_postgres stonith_postgres
> 
> You're missing location constraints, and doing this with 2 primitives
> rather than 1 clone is usually cleaner. The example below is for
> external/libvirt rather than external/ssh, but you ought to be able to
> apply the concept anyhow:
> 
> http://www.hastexo.com/resources/hints-and-kinks/fencing-virtual-cluster-nodes
> 

As is understood the cluster decides which node has to be stonith'ed. Besides this, I already tried the following configuration:

crm configure primitive stonith1_postgres stonith:ssh \
	params hostlist="node1"
	op monitor interval="25" timeout="10"
crm configure primitive stonith2_postgres stonith:ssh \
	params hostlist="node2"
	op monitor interval="25" timeout="10"
crm configure location stonith1_not_on_node1 stonith1_postgres \
	-inf: node1
crm configure location stonith2_not_on_node2 stonith2_postgres \
	-inf: node2

The result is the same :/


> Hope this helps.
> Cheers,
> Florian
> 

Best
Mathias

-------------- next part --------------
An HTML attachment was scrubbed...
URL: <https://lists.clusterlabs.org/pipermail/pacemaker/attachments/20120320/e3f1ecf5/attachment-0003.html>